Angle stop
Use the angle stop
diagonal) or diffi cult-to-reach places.
♦
Fold out the angle stop
Fig. 2
Measuring lengths
Single measurements
♦
Place or hold the reference plane of the device on or against
the desired base surface from which you want to determine
a distance.
♦
Briefl y press the
Once the laser is switched on, this is indicated on the display
by the
♦
Now aim the laser at the target point.
♦
Briefl y pressing the
urement to be taken.
If the measurement is successful, the measurement result
shown on the display
The previous readings
PLEM 50 A1
if you are measuring from corners (room
button
ON
icon
.
button
ON
.
and
as shown in Figure 2.
to activate the laser.
again will cause the meas-
are pushed upwards.
GB
IE
is
11