Continuous Measurement; Measurement Value Functions - Parkside PLEM 50 A1 Bedienungsanleitung

Continuous measurement

GB
Continuous measurement involves taking series of measurements
IE
from which the maximum (
are displayed. To do this, move the device along a base surface
or an edge from which you want to the measure the distances. You
can, for example, measure how parallel two opposite walls are or
measure the maximum values while using a function.
♦ Start the continuous measurement by pressing the
for more than one second.
Each measured value is shown on the display
♦ Stop the measurement by pressing the
The display
minimum value (
measured value

Measurement value functions

To make it easier to process measurement results, the device off ers
a number of integrated functions.
♦ By pressing the
following functions one after the other:
area, volume, simple Pythagoras, double Pythagoras.
The desired function must be selected before the measurement.
After taking a measurement in the selected function, the last selected
function is reactivated.
Area
♦ Press the
display
♦ Now measure the length and width of the area to be meas-
ured by pressing the
measurements).
12
)
now shows the maximum value (
) of the measurement series and the last
.
button
FUNC
button once. The
FUNC
.
button
ON
and minimum values (
button
ON
repeatedly, you can activate the
icon appears on the
(see also Chapter Single
)
button
ON
.
.
) and the
PLEM 50 A1