Handling and operation
GB
IE
Selecting the length unit
The length unit
♦
Press and hold the button
You can set the following length units in this order:
Length
0.000 m
0.000 ft
0' 0" 1/16 in
0' 0" 1/16
Selection of the reference plane
The lower reference plane
upper reference plane
the contact surface for a measurement.
The reference plane is to be set before measurement otherwise the
measurement result diff ers from the actual value.
The reference plane
♦
You can change the reference plane by pressing the
briefl y.
The selected reference plane
10
used after switch-on is the last-used unit.
UNIT
Area
0.000 m
2
0.000 ft
2
0.00 ft
2
0.00 ft
2
(base) or the angle stop
(cover side) of the device can be used as
(base) is set when the device is switched on.
to select another unit.
Volumes
0.000 m
3
0.00 ft
3
0.00 ft
3
0.00 ft
3
is shown on the display
or the
button
.
PLEM 50 A1