Stihl MOW 5.0 EVO Bedienungsanleitung Seite 57

4 Safety Precautions
► Insert mains plugs only in a properly instal‐
led and fused wall socket.
► If the wall socket is outside of a building:
Make sure that the socket is approved for
outdoor use.
► Install the power supply with a fault current
circuit breaker (30 mA, 30 ms).
► If the connecting cable or extension cable is
connected or disconnected, always grip the
plug and do not pull on the cable.
■ A damaged or unsuitable extension cable can
result in electric shock. There is a risk of seri‐
ous or fatal injury.
► Use an extension cable with the correct
cable cross-section,
► Use a splash water protected extension
cable approved for outdoor use.
► Protect plug connection between the power
supply and extension cable against water.
► Use an extension cable with the same
specifications as the power supply's con‐
necting cable.
WARNING
■ An incorrect line voltage or mains frequency
can result in an overvoltage in the power sup‐
ply. The power supply may be damaged.
► Make sure the line voltage and mains fre‐
quency match the data on the power sup‐
ply's rating label.
■ If the power supply is connected to a power
strip, electrical components may be overloa‐
ded during the charging process. The electri‐
cal components may overheat and cause a
fire. Persons may be seriously or fatally
injured, and property may be damaged.
► Ensure that the technical specifications for
the power strip are not exceeded by the
information on the rating plate of the power
supply and of all electrical devices connec‐
ted to the power strip.
■ An improperly routed connecting cable, exten‐
sion cable or charging cable can be damaged
and cause people to trip over them. This may
result in serious injury to people and damage
to property.
► Route the wires and charging cable so that
they are outside of the mowing area.
► Route and mark the wires and charging
cable so that they will not be damaged by
work with a gardening device or tool.
► Route and mark the wires and charging
cable in such a way that people cannot trip
over them.
0458-012-9601-A
23.5.
► Route the wires and charging cable in such
a way that they are not under tension or
tangled.
► Route the wires and charging cable in such
a way that they will not be damaged, bent,
crushed or will not chafe.
► Protect the wires and charging cable from
heat, oil and chemicals.
► Route the wires and charging cable so that
they are not on a permanently wet surface.
■ If electrical wiring and conduits are routed in
the wall, they may be damaged if the power
supply is mounted on the wall. Contact with
wiring can result in electric shock. This may
result in serious injury to people and damage
to property.
► Make sure there is no electrical wiring or
conduits in the wall at the proposed mount‐
ing site.
► Mount the power supply on a wall as descri‐
bed in this User Manual.
■ If the power supply is connected to a genera‐
tor, the electricity supply cannot be perma‐
nently ensured and the robot mower may not
function properly. The power supply may be
damaged by fluctuations in the electricity sup‐
ply.
► Only connect the power supply to a prop‐
erly installed socket.
4.10 Transporting
4.10.1 Robot mower
WARNING
■ The robot mower may tip over or move during
transport. This may result in injury to people
and damage to property.
► Stop the robot mower and activate
the device lock.
► Secure the robot mower with lashing straps,
belts or a net so that it cannot tip over or
move.
4.10.2 Battery
The battery has been installed in the robot
mower and must only be removed by a STIHL
authorized dealer.
WARNING
■ The battery is not protected against all envi‐
ronmental conditions. The battery may be
damaged if it is exposed to certain ambient
English
57