Repairing - Stihl MOW 5.0 EVO Bedienungsanleitung

21 Repairing

5
► Clean, blade disk (5), blade carrier (6) and
nut (4).
8
8
► Attach new blades (8). Insert only one blade
per pin (9).
6
► Put on the blade carrier (6).
► Push the blade carrier (6) in the direction of
the arrow and make sure that all three
arms (10) underneath the pins (9) are posi‐
tioned.
The blade carrier (6) is locked.
► Position the blade disk (5) on the robot mower.
► Press and hold the lever (3).
► Turn the nut (4) clockwise.
► Release the lever (3) and tighten nut (4)
securely clockwise.
The levers (3) engage audibly.
21 Repairing
21.1 Repairing the robot mower,
battery, blades, docking station
and power supply
Users cannot repair the robot mower, battery,
docking station and power supply themselves.
0458-012-9601-A
4
6
9
8
9
10
10
10
Damaged or worn blades can be replaced.
► If the robot mower, battery, docking station,
charging cable, power supply or connecting
cable is damaged: Do not use the robot
mower, battery, docking station, charging
cable, power supply or connecting cable and
contact a STIHL authorized dealer.
► If a blade is damaged or worn:
► Stop the robot mower and activate the
device lock.
► Replace all blades. The blades cannot be
re-sharpened.
► If warning labels are illegible or damaged:
Have the warning labels replaced by a STIHL
authorized dealer.
21.2 Extending or repairing perime‐
ter wire or guide wire
The perimeter wire or guide wire can be exten‐
ded or repaired using wire connectors.
Wire connectors are filled with gel to prevent pre‐
mature wear or corrosion of the wire ends.
► Make sure that the overall length of the perim‐
eter wires does not exceed the maximum
length of 850 m.
2
1
► Insert the wire ends (2) into the wire connec‐
tors (1).
Do not strip the wire ends.
► Press the wire connector (1) together up to the
limit stop with a pair of pliers.
► Route perimeter wires at least for a length of
a = 5 cm parallel and close together without
the perimeter wires crossing over each other.
English
a
87