Maintenance - HPA-Faip M 928 ROYAL Betriebs- Und Wartungsanleitung

MAINTENANCE

CAUTION
The "Spare parts" handbook does not authori-
se users to carry out work on the machine with
the exception of those operations expressly
described in the user manual. It only enables
users to provide the technical assistance
service with precise information in order to
minimise delays.
WARNING
SIMPESFAIP declines all liability for claims
deriving from the use of non-original spare
parts or accessories.
CAUTION
Any operation intended to modify the setting
value of the relief valves or pressure limiter
is forbidden.
The manufacturer declines all liability for
damage resulting from tampering with these
valves.
WARNING
Before adjusting or servicing the machine,
disconnect the electricity and compressed
air supplies and make sure that all moving
parts are suitably immobilised.
CAUTION
Do not remove or modify any parts of this
equipment except in the case of service
operations.
DANGER
When the machine is disconnected from the
air supply system, the devices marked with
the warning sign shown above may remain
pressurised.
- The filter+regulator+lubricator is equipped with
a semiautomatic condensation drain device.
This device operates automatically whenever
the compressed air supply to the machine is
cut off.
84
Drain the condensation manually (push-button
C, fig. 35) when the level exceeds the mark X,
fig. 35.
- Clean the top plate of the turntable every week:
remove any accumulated dirt and clean with
environmentally-friendly solvents.
- Monthly checks:
• Clean the arms of the tool-carrying head,
the bead breaking unit and the relative travel
screws with environmentally-friendly solvents
only. Lubricate.
• Check the oil level in the air lubricator (fig. 35)
and, if necessary, top up with non-detergent
SAE20 oil to the indicated level Z.
• Clean with a dry cloth. Avoid contact with
solvents.
• Check the oil flow-rate through the transparent
cover K (correct flow-rate: 1 drop of oil every
4 bead breaking cycles). Adjust if necessary
by turning the set screw Y fig. 35.
CAUTION
Keep the working area clean.
Never use compressed air, jets of water or solvent
to remove dirt or deposits off the machine.
When cleaning, take care not to create and raise
dust as far as possible.
User Manual M 928 ROYAL