Safety Regulations - HPA-Faip M 928 ROYAL Betriebs- Und Wartungsanleitung

machine - see "Technical Data" section. For
correct machine operation the compressed air
supply line must provide a pressure range from
no less than 8 bar to no more than 16 bar.
Connect the compressed air system by means
of a supply pipe connected to the intake of the
air treatment unit on the REAR SIDE of the
machine base.
Check that there is air lubrication oil in the
Lubricating unit; refill if there is little or no oil.
Use SAE20 oil.
The customer must provide an air cut-off valve
upstream of the air treatment and regulating
device supplied with the machine.
WARNING
Connection 1 should be considered as an
emergency valve to disconnect the machine
from the air line (fig.6)
54

SAFETY REGULATIONS

The equipment is intended for professional
use only.
WARNING
Only one operator may work on the equip-
ment at a time.
WARNING
Failure to comply with the instructions and
danger warnings may seriously injure ope-
rators and any other person present near
the machine. Do not operate the machine
until you have read and understood all the
danger, warning and caution notices in this
manual.
This machine must be used only by qualified
and authorised personnel. A qualified operator
is construed as a person who has read and
understood the manufacturer's instructions, is
1
suitably trained, and is conversant with safety
and adjustment procedures to be adhered to
during operations. Operators must not use the
machine under the influence of alcohol or drugs
which may affect their capacity.
The operator must, in all cases:
- Be able to read and understand all the infor-
mation in this manual.
6
- Have a thorough knowledge of the capabilities
of this machine.
- Keep unauthorised persons well clear of the
area of operation.
- Make sure the machine has been installed in
compliance with all relevant regulations and
legislation.
- Make sure that all machine operators are su-
itably trained, that they are capable of using
the equipment correctly and that they are
adequately supervised.
- Never leave nuts, bolts, tools or any other
equipment on the tyre changer as they may
become entrapped between moving parts.
- Not touch power lines or the inside of electric
motors or any other electrical equipment be-
fore making sure the power supply has been
disconnected.
- Read this manual carefully and learn how to
use the machine correctly and safely.
- Always keep this user and maintenance manual
in an easily accessible place and consult it
whenever necessary.
User Manual M 928 ROYAL