Hoisting/Handling; Installation Clearances; Ambient Working Conditions - HPA-Faip M 928 ROYAL Betriebs- Und Wartungsanleitung

HOISTING/HANDLING

In order to remove the machine from the pallet,
hook it up as shown in fig. 2.
This hoisting point must be used whenever you
need to change the installation position of the
machine. Do not attempt to move the machine
until it has been disconnected from the electricity
and compressed air supply systems.
INSTALLATION
CLEARANCES
WARNING
The installation site must be chosen in strict
compliance with the relevant regulations
regarding Safety in the workplace.
IMPORTANT: for correct, safe use of the equi-
pment, users must ensure a lighting level of at
least 300 lux in the place of use.
52
CAUTION
If the machine is installed outdoors, it must
be properly sheltered under a roof.
WARNING
The floor must be able to withstand a load
equal to the sum of the weight of the equip-
ment itself and the maximum payload, bearing
in mind the support surface area and eventual
anchor fixtures used.
Install the tyre changer in the chosen work po-
sition, complying with the minimum clearances
shown in fig. 3.
The machine must be placed on a horizontal
surface, preferably concrete or tiled floor. Do not
install on unstable or damaged surfaces.
The surface on which the machine rests must
withstand the loads transmitted during operation.
The surface must have a load-carrying capacity
of at least 500 kg/m
2
1200

Ambient working conditions

- Relative humidity 30% ÷ 95% without conden-
sation.
- Temperature 0°C ÷ 50°C.
WARNING
Use of the machine in a potentially explosive
atmosphere is not permitted.
.
2
500
User Manual M 928 ROYAL
3