Input" Menu - Sartorius Entris II Essential Serie Betriebsanleitung

7.3.20 "INPUT" Menu

Parameter Setting values
DEV. ID
LOT ID PRINT
CONTENT**
SPL. ID PRINT
START V.****
MODE**
DATE
TIME
USER.PW
DEL. PW.****
SERV.PW
CAL.WT.
INTERV.
* Factory setting
** Only visible if "PRINT" / "ON" is selected
*** Only possible if "BARCODE" is selected (see Kapitel „7.3.3 "DEVICE" / "RS232" Menu", Seite 21)
**** Only visible if "SPL. ID" / "MODE" / "SCAN" is not selected. Only visible if the user password is available.
Setting values Explanation
Max 14 characters Saves the entered ID number for the device.
09-0, A-Z, - ,
empty
ON Activates the output of the lot ID number during GLP
output.
OFF* Deactivates the output of the lot ID number during
GLP output.
Max 14 characters Content of the LOT ID.
09-0, empty
ON Activates the output of the SPL. ID number during
GLP output.
OFF* Deactivates the output of the SPL. ID number during
GLP output.
Max 14 characters Start value of the SPL. ID.
09-0, A-Z, - ,
empty
COUNT.UP* The SPL. ID number is counted up on each printout.
COUNT.DN The SPL. ID number is counted down on each print-
out.
SCAN*** The SPL. ID number is read in by the barcode scanner.
Printing then occurs automatically.
Saves the entered date.
Saves the entered time.
Max 7 characters Saves the entered user password.
09-0, A-Z, - ,
empty
YES Deletes the entered password.
NO* Does not delete the entered password.
Max 7 characters Activates service mode.
09-0, A-Z, - ,
empty
Changes the calibration weight for the adjustment or
calibration process with the user-defined weight
value.
The SBI output rate can be set from 0 - 9999 seconds.
System Settings
Entris BCE Operating Instructions
®
29