Sartorius Entris II Essential Serie Betriebsanleitung Seite 20

System Settings
Parameter Setting values
APP.FILT. FINAL.RD.*
FILLING
STAB.RNG V. ACC.
ACC.*
FAST
V. FAST
ZER./TAR. W/O STB.
W/ STAB.*
AUTOZER. ON*
OFF
WT.UNIT GRAMS*, KILOGR.,
CARATS,
POUNDS,
OUNCES, TROY.
OZ., HKTAEL,
SNGTAEL,
TWNTAEL,
GRAINS,
PENYWT.,
MILLIGR., PTS./LB,
CHNTAEL.,
MOMMES, AUSTR.
CT, TOLA, BAHT,
MESGHAL,
NEWTON
DISP.DIG. ALL*
MINUS 1
CAL./ADJ. EXT.CAL.
E.CAL.USR.
REPRO
SELECT
INT.CAL.*
* Factory setting
20 Entris BCE Operating Instructions
®
Explanation
Activates a filter that enables a fast change in the display for very fast load
changes. Display changes with minimal load changes (in the digit range)
occur more slowly.
Activates a filter that enables a very fast change in the display with minimal
load changes, e.g. when filling containers.
Sets the stability to "very accurate".
Sets the stability to "accurate".
Sets the stability to "fast".
Sets the stability to "very fast".
If the button is pressed: The function of the [Zero] or [Tare] button is
executed immediately.
The function of the [Zero] or [Tare] button is only executed after stability is
achieved.
Activates automatic zeroing. The display is automatically set to zero in case
of a deviation of 0 less than (X).
Deactivates automatic zeroing. Zeroing must be triggered with the [Zero]
button.
— The device displays the weight in the selected unit.
— The availability of units depends on national legislation and is therefore
country-specific.
"Show all decimal places": All decimal places are shown in the display. The
setting change is not available on conformity-assessed devices.
"Last decimal place off": The last decimal place is switched off.
The [Adjust] button starts an external calibration and adjustment process
with the preset calibration weight.
The [Adjust] button starts an external calibration and adjustment process
with the user-defined calibration weight value.
Starts the reproducibility test. Determines the current calibration frequency
with a user weight.
The interface [CAL] is assigned a selection of permitted menu items from
"CAL./ADJ."
The [Adjust] button starts an internal calibration and adjustment process.