System Overview - Kärcher SB MB Bedienungsanleitung

Expansion tank
1
Fuel filter and fuel pump
2
Burner with booster heater
3
High-pressure pump 2
4
High-pressure pump 3
5
High-pressure pump 1
6
High-pressure pump 4
7
Pressure gauge of high pressure pump
8
Hot air blower
9
Tool storage trough
10
Frost protection pump filter
11
Detergent container for Top-Care
12
Detergent container for hot wax
13
Detergent container for high-pressure wash
14
Detergent container for dry foam
15
Fuel tank, 60 l (option) *
16
Pump attachment kit disconnection from mains (op-
17
tional)
Wheel cleaner (option) *
18
Salt tank
19
Drain valve
20
Stop valve of fresh water
21
Washing station heater circulation pump
22
Thermostatic mixing valve
23
Safety valve
24
Pressure gauge of washing station heater
25
Active carbon filter WSO
26
Fine filter WSO
27
Hot water float tank
28
Recirculation fan
29
Blending device (option)
30

System overview

* Depending on the equipment of the system, the inten-
sive foam assembly may also be fitted at these points.
Menu Maintenance Diagnostic
The Maintenance Diagnostic menu shows the times un-
til the next maintenance, system information, error mes-
sages and events.
"Event History" menu button
1
"Fault History" menu button
2
"System Information" menu button
3
"Interval" menu button
4
Menu Interval
In the Interval menu, the time until the next maintenance
is displayed for the individual system components.
Next window button
1
English
Previous window button
2
Service counter (remaining time until next mainte-
3
nance)
Component
4
Reset service counter button
5
–
green: remaining operation duration more than
30% of the total time
–
orange: remaining operation duration less than
30% of the total time
–
red: Service counter expired, maintenance must
be carried out
If a service counter has expired, the controller displays
a maintenance request in the standard setting:
Call up interval directly
1
Skip this message and call up the start display of
2
the controller
"Service Interval Reached Please Schedule Main-
3
tenance"
Reset service counter
Note
The following service counters can be reset by the op-
erator:
● Replace the filter element WSO
● Vacuum cleaner 1...6, filter 1
● Vacuum cleaner 1...6, filter 2
● Drain the compressor
● Check the frost protection
65