Settings; Adjusting The Compressor - Kärcher SB MB Bedienungsanleitung

Dry foam station
1
Touchscreen
2
Control cabinet
3
Main switch
4
Dosing pump of dry foam station
5
Hot air blower
6
Dosing pumps
7
Frost protection with water loss (option), installation
8
location 2
Frost protection with water loss (option), installation
9
location 1
Emergency frost protection (option)
10
Wheel cleaner (option)
11
Heat exchanger of washing station heater
12
Base exchanger head
13
Blending device (option)
14

Settings

Main switch
Position Function
1 The system is in operation.
The frost protection devices (option)
are active.
0 The entire system is out of operation
(including the frost protection devices).

Adjusting the compressor

1. Set the pressure reducer 0.4...0.5 MPa (4...5 bar).
Pressure switch for air
1
Pressure gauge
2
Compressed air connection for service work
3
Pressure reducer
4
English
Setting the dosing pumps
The dosing pumps add detergents and care agents to
the washing water according to the washing programme
and the equipment in the system.
Note
The dosing quantities are adjusted optimally by the in-
stallation technician during initial commissioning.
Changes to these settings are not usually necessary.
Fine adjustments are made on the controller (see "Con-
troller/Menu Settings/Menu/ Washing programme set-
tings"). The standard setting of the dosing pumps is not
changed.
Dosing pump of high-pressure wash (DP 1)
1
Dosing pump of hot wax (DP 2)
2
Dosing Pump of Top-Care (DP 3)
3
Dosing pump optional (DP 4), for additional pro-
4
grammes
47