Quick Drive Programming - krispol STARCUS F50 Montageanleitung

QUICK DRIVE PROGRAMMING

FUNCTION
1. Press and hold
the RAIL SYSTEM
button for 3 sec.
2. Short press of
/
helps to select
the track system
of your choice.
3. Short press of
confirms the
track system
selection
4. Press and hold
the button.
/
5. Press and hold
the button.
/
54
DESCRIPTION
All LEDs under the SL, HL, and VL track system markings will be lit.
Then release the button, one of the LEDs will
start blinking.
The corresponding LED will flash under the selected
SL, HL, VL type.
SL: standard track system with basic drums.
HL: superior track system with straight-conical
drums.
VL: vertical track system with conical drums.
The corresponding LED will be lit under
the selected SL, HL, VL type.
Then the digital display will show
top position of the door (fully open).
Use the + (up) and - (down) buttons to set the door to the open
position. Then press the SET button briefly to save the top position.
Then the digital display will show
bottom position of the door (fully closed).
Use the + (UP) and - (DOWN) buttons to set the door to the closed position.
Then briefly press the SET button to save the bottom position.
Then the drive will start opening and closing the door one by one in order
to check the weight of the door to remember the track system and balance
characteristics.
Note:
a. If an error occurs during the autotuning process, press the button to interrupt
the programming process. Check the mechanical parameters of
the door and perform the adjustment of the door leaf balance.
Then repeat the programming procedure from the beginning.
b. If the completion of the auto-adjustment process is impossible, set the
parametersoperation of the drive manually according to the further instruc-
tions described in this manual.
to start programming the
to start programming the