krispol STARCUS F50 Montageanleitung Seite 67

SETTINGS OF FUNCTION PARAMETERS IN MENU
6. —
MENU 6
6.0
Partial opening
height setting
6. 1
Setting of PB1-(NO)
control input parameters
Settings of auxiliary functions parameters
5.0 6.0
Note
6.1
Press and hold the SET button for about 6 se-
conds until the display shows 0.-; then release
the button
- use the + button to select 6.- ;then briefly
press the SET button to select this parameter;
- press the SET button again; the display will
show 6.0 (default);
- press the SET button again to select this
parameter, and the display will show
for a moment, and then flashing
Use the +/- buttons to select the parameter from
. 1 .9
to
(value 9 corresponds to 9x10% = 90% of the door
opening)
Press the SET button to save this parameter and
exit the settings to MENU
You can continue the settings of the subsequent
functions or press the RAIL SYSTEM button to
exit the MENU.
.5
default setting
This means partial opening of the door to 50%
of the door height.
Press and hold the SET button for about 6 se-
conds until the display shows 0.-; then release
the button;
- use the + button to select 6.-; then shortly press
the SET button to select this function;
- press the SET button again and the display will
show 6.0 (default);
- use the + button to select 6.1 ; then short press
the SET button to select this function and display
the parameters:
.5
1.0
67