krispol STARCUS F50 Montageanleitung Seite 70

SETTINGS OF FUNCTION PARAMETERS IN MENU
6. 4
Beacon settings
70
6.4 Press and hold the SET button for about 6 se-
conds until the display shows O.; then release the
button
- use the + button to select 6.; then shortly press
the SET button to select this function
- press the SET button again and the display will
show 6.0 (default)
- use the + button to select 6.4; then shortly press
the SET button to select this function and display
the parameters:
. 1 The beacon flashes when the door is moving.
The beacon is on when the door is moving.
. 2
. 3 The beacon flashes when the door is moving
or stopped
The beacon is on when the door is moving or
. 4
has been stopped.
. 5 The beacon flashes when the door is moving and
lights up when it has been stopped.
The beacon is on when the door is moving and
. 6
flashes when it is stopped.
. 1
Note
By default