SETTINGS OF FUNCTION PARAMETERS IN MENU
8. 1
Check the number
of cycles before the sub-
sequent maintenance of
the device
8.1
Press and hold the SET button for about 6 se-
conds until the display shows 0.; then release the
button
- use the + button to select 8.;then press the SET
button shortly to select this function The display
shows 8.1; then shortly press the SET button to
select the parameter
The display will loop repeatedly three times and
after that the menu
- 10 00 -
will be exited.
Note
a. the counter will display the number of cycles
performed even after the reset to the factory
settings.
b. each cycle consists of the process of the
door opening and closing.
c. when the warning counter shows 0, the
beacon will flash quickly while the door is mo-
ving, and the connected buzzer will work to re-
mind the user about the required maintenance.
The display will show the
d. after performing maintenance on the device,
the installer must set the number of cycles un-
til the subsequent maintenance.
E 8 error.
77