krispol STARCUS F50 Montageanleitung Seite 73

SETTINGS OF FUNCTION PARAMETERS IN MENU
6. 7
XH06-2 relay
output settings
6.7 Press and hold the SET button for about 6 se-
conds until the display shows 0.;then release the
button
- use the + button to select 6.; then shortly press
the SET button to select this function
- press the SET button again and the display will
show 6.0 (default)
- use the + button to select 6.7; then short press
the SET button to select this function and display
the parameters:
. 1
Contact closed when the door is fully open.
. 2
Contact closed when the door is fully closed.
. 3
Contact closed when partial opening is reached.
Before the drive starts, the contact is closed
. 4
(for an adjustable time within the range of 1-7
s.) To change this parameter, press SET and
use the +/- buttons to set the parameter from
1 7
to
3
by default - 3 min.
Contact closed while the door is moving. After
. 5
stopping, the contact is open (for an adjustable
time within the range of 1-10 min.) To change this
parameter, press the SET button and using the +/-
buttons set the parameter
1 A
from to
A
- while
3
by default is -3 min.
means 10 min.
73