General Safety Information - krispol STARCUS F50 Montageanleitung

GENERAL SAFETY INFORMATION

Intended use
The drive designed for automating industrial sectional doors.
The safe operation of the drive is only guaranteed when properly selected and instal-
led in accordance with this installation and user manual.
The drive with IP 54 enclosure must be protected against rain, excessive moisture and
other adverse environmental conditions. The manufacturer is not liable for any dama-
ge caused by a different use of the device or failure to follow the instructions below.
Modifications to the device are allowed only with the prior consent of the manufactu-
rer.
Otherwise, the Manufacturer's Declaration is null and void.
Safety
Installation and commissioning may only be performed by qualified personnel.
Only trained and licensed installers may work on electrical devices. They must be able
to properly assess the tasks entrusted to them, inspect the place of installation of
the device and introduce appropriate safety measures. Any installation work must be
carried out with power off. The applicable laws and standards must be observed.
WARNING: Important safety instructions:
- All the instructions must be observed for the safety of people. Keep the manuals for
further use.
- Do not let children play with the device or controls, including the remote control.
- Follow all the instructions. Improper installation can lead to serious injuries.
- The operator control buttons must be installed in the way allowing for the direct
adjustments of the operation, but away from moving parts. If the drive is not activa-
ted with the key, the buttons (of the control unit) must be placed at a minimum height
of 1.5 m.
After completing the installation, make sure that the functions of the drive are proper-
ly set up and all safety devices and additional drivers are working properly.
Safety covers and accessories
The device may only be operated with drive/control panel covers and required safety
devices installed.
Ensure the correct fitting of the gaskets and the proper tightening of the cable glands.
Measured motor noise level LpA <70 dB (A).
Note:
The measurements do not include the noise level emitted by the structure of the door
itself.
45