krispol STARCUS F50 Montageanleitung Seite 65

SETTINGS OF FUNCTION PARAMETERS IN MENU
5. —
MENU 5
5. -
Enabling and
disabling the safety input
for photocells or light
curtains
5. 1
Enabling and disa-
bling the safety input for
photocells and light curta-
ins and activation of the
Auto Close function.
Setting of PE safety input parameters
5.-
5.0
Press and hold the SET button for about 6 se-
conds until the display shows 0.-; then release
the button
- use the + button to select 5.-; then shortly
press the SET button to select this parameter
Press the SET button again, and
on the display (default). Using +/- buttons select a
5.0
parameter from
5.0
function of safety input is disabled
5.1
function of safety input is enabled
5.2
the light curtain recognition function is
activated
5.0
When selecting
button to select this parameter and return to the
MENU
When selecting the
the SET button to select this parameter.
The display will show
parameter has been changed to use the auto-
matic closure function.
Use the +/- buttons to select
parameter from
pressing the SET button. This function enables
the operation of the safety input.
The safety input was not activated
the safety input has been activated and the
automatic closing function can be activated.
5.0
appears
5.1 5.2
to
shortly press the SET
5.1
button, briefly press
to confirm that the
to and confirm by
65