SETTINGS OF FUNCTION PARAMETERS IN MENU
1. 1
Correcting the cut-off
height of the edge
protection operation
1. 2
Correction of the
OPEN travel limit position
58
1. 1
Use the + button to select 1.1 then shortly press
the SET button to select this parameter.
.8
The display shows
Select the parameter from
+/- buttons, then shortly press the SET button
to select this parameter and go automatically
1.2
to
to continue setting the next functions,
or the RAIL SYSTEM button to exit the MENU
settings
Note:
Depending on the track system of the door and
the size of the drums, the adjustment range
for each setting falls between 20mm to 50mm
(based on the type of drum installed).
.8
For the
[8] x2x2.2 [mm]
1. 2
Press and hold the SET button for about 6
seconds until the display shows 0.- ; then
release the button
- use the + button to select 1.-; then shortly
press the SET button to select this parameter
- 1.0 appears on the display
- use the + button to select 1.2
- 5
Then shortly press the SET button; the display
starts blinking
-F
within
briefly press the SET button to select this para-
meter and automatically go to
setting other functions, or the RAIL SYSTEM
button to exit the settings MENU
.8
.1
parameter it is about 35 [mm]
-5
, Select the parameter
0
F
...
to
using the +/- buttons then
.F
to
using the
1.3
to continue