krispol STARCUS F50 Montageanleitung Seite 75

SETTINGS OF FUNCTION PARAMETERS IN MENU
7. —
MENU 7
7.-
Courtesy Light
Setting
Courtesy Light Setting
7.-
Note
Press and hold SET button for about 6
seconds to enter main menu until "0.-"
appears on the display; then release the
button.
- press + button till " 7.- " appears on the
Display; then briefly press the SET button to se-
lect this function
- press the SET button again; the display will
7.3
show (by default).
Using the +/- buttons set the parameter
7.1 7.9
between to
7.3
by default, means 3 minutes of extra
operation.
Settings 1-9 correspond to 1-9 minutes. Set the
time of additional lighting and accept by pres-
sing SET. Then set the way the courtesy light
.0
works. , appears on the display.
By using +/- buttons set the parameter from
.0 .9 .0
to means the operation of the
courtesy light is off
.0 .9
to is the warning time in seconds befo-
re the drive starts operating.
a. After stopping the drive, the courtesy
lighting will operate in the set time range
of 1-9 minutes.
7.3
setting means 3 min. of additional
operation.
b. Before the drive starts operating for a spe-
cified period of 0-9 seconds, the lighting will
blink to indicate that the drive is running.
75