SETTINGS OF FUNCTION PARAMETERS IN MENU
6. 8
Settings security
inputs edge
74
. 6
Contact closed while the door is moving.
. 7
The contact opens and closes with the frequ-
ency of 1 Hz. Closed during door movement
(additional function for beacon).
. 8
Relay output operation disabled.
. 8
Note
by default
It is possible to select the operation mode of
the NO or NC relay
6.8
Press and hold the SET button for about 6 se-
conds until the display shows 0.; then release the
button
- use the + button to select 6.; then shortly press
the SET button to select this function
- press the SET button again and the display will
show 6.0 (default)
- use the + button to select 6.8; then short press
the SET button to select this function and display
the parameters:
. 1
Amperometric protection. Use 8.2K resistor
without self-test.
. 2
Digital input (OSE), 3-wire
. 3
Pneumatic rail (DW). Note: Use an 8.2K
resistor for the DW self-test.
E
error code is displayed when DW
self-learning has failed; please refer to the
error report page for the appropriate solution.
Note
8.2k resistance input set as default.