Storage; Waste Disposal And Environmental Protection - Parkside PTPK 270 A1 Originalbetriebsanleitung

GB
• With a water jet, remove fl uff and
fi brous particles which are possibly
present in the pump casing (3).
• Clean precipitation from the fl oat
switch (5) with clear water.
• Regularly remove sludge from the pit
base (at the latest every 3 months) and
also clean the shaft walls.
• Dirt on the bottom of the pump can be
washed down with clear water.
Any measures above and beyond these,
particularly opening the equipment, are
to be carried out by an electrician. In the
case of repairs, always contact our service
centre.

Storage

• Clean the pump before storage.
• Store the appliance in a dry, frost-free
place, and where children cannot gain
access to it.
• When the pump is not to be used for
a longer period, it must be thoroughly
cleaned after its last use, and before it
is next used. Otherwise there may be
problems in starting the pump, caused
by deposits and residues.
• Coil up the power cord (2). Hang the
power cord (2) around the fl oat switch
(5) mounted in the fl oat switch guide
(8), see illustration
26
.
Waste Disposal and En-
vironmental Protection
Be environmentally friendly. Return the
tool, accessories and packaging to a recy-
cling centre when you have fi nished with
them.
Electric appliances should not be
disposed of in the domestic gar-
bage.
Directive 2012/19/EU on waste electrical
and electronic equipment: Consumers are
legally obliged to recycle electrical and
electronic equipment in an environmentally
sound manner at the end of its life. In this
way, environmentally friendly and resource-
saving recycling is ensured.
Depending on implementation in national
law, you may have the following options:
• Return to a shop,
• Hand over to an offi cial collection point,
• Return to the manufacturer/distributor.
This does not affect accessories enclosed
with the old devices or tools without any
electrical components.