Air Vertical Flow Adjustment; Dehumidification; Timer Operation; Modifications - Olimpia splendid NEXYA S5 E DUAL Hinweise Für Die Verwendung Und Pflege

8.4.1 - Air vertical flow adjustment

The air conditioner automatically adjusts the vertical flow of air, depending on the operating mode.
Activate this function while the unit is active.
• The SWING/DIRECT buttons will be disabled when the air conditioner is not operating
(also when the TIMER ON is set).
• Do not activate the air conditioner for long periods with the air downwards in cooling
or dehumidification modes.
Otherwise, humidity may form on the surface of the horizontal louvres, which could
fall onto the floor or furnishings.
• Do not move the vertical openings manually.
Always use the SWING button. If directed manually, malfunctioning may occur. If louvre
malfunctioning occurs, stop the conditioner and re-start it.
• When the conditioner is switched on immediately after it has been switched off, the
horizontal louvres may not move for approx. 10 seconds.
• The angle of opening of the horizontal louvres must not be too small, since performance
in COOLING or HEATING mode may not be perfect for the flow of air that is too narrow.
• Do not activate the equipment with the openings in closed position.
• When the air condition is connected to the power supply (initial supply), the openings
may cause a noise for 10 seconds. This is normal operation.

8.5- DEHUMIDIFICATION

START
Check that the unit is connected and is powered electrically.
a. Press the "MODE" key (1) to select "DRY" mode.
b. Set the desired temperature by pressing the "TEMP" keys (4).
c. When the remote control is "OFF", press the "ON/OFF" key (2) to start the air conditioner.
STOP
a. Press the "ON/OFF" key (2) to stop the air conditioner.
Fan speed cannot be adjusted when the unit is in AUTO and DRY modes.

8.6- TIMER OPERATION

START
Check that the unit is connected and is powered electrically.
a. Press one of the TIMER keys (7 and 8) as desired.
The current adjustment of the timer is shown on the display at the side of the Timer ON and Timer OFF
indicators and will flash.
b. Press the "TEMP" keys (4) to select the desired time.
Forward
Backward
Every time one of the "TEMP" keys (4) is pressed, the time moves forward or backward by 30 minutes,
depending on the direction of pressing.
c. Once the time has been set for TIMER ON and TIMER OFF, check that the TIMER indicator on the indoor
unit display is on.

MODIFICATIONS

• Repeat phases "a", "b" and "c" to change the settings.
8.6.1 - Switch-on timer setting from the remote control (figures 18, 19 and 22)
When the unit has been switched on, select the operational mode, the desired temperature and fan speed
with which the unit will activate on scheduled switch-on.
Successively put the machine in Stand-By. Press the "TIMER ON" key (7) to set the desired delay (from 1 to
24 hours), after which the unit will switch on (starting from confirmation of the timer).
EN - 40