Follow Me Function; Turbo Function; Self Clean Function; Silence Function - Olimpia splendid NEXYA S5 E DUAL Hinweise Für Die Verwendung Und Pflege

8.3.3 - Follow Me function

The remote control acts as a remote thermostat, allowing correct control of the temperature in its position.
• To activate the Follow Me function, point the remote control towards the unit and press the "Follow Me"
button.
The remote control displays the real temperature in its own position and sends this signal to the air
conditioner every 3 minutes, until the button is pressed again.
If the unit does not receive the Follow Me signal for 7 minutes, it emits a "beep", which signals that the
Follow Me mode has ended.
The Follow Me function is not available in the DRY and FAN mode.
• If the operating mode is pressed, or the unit is switched off, the Follow Me function is annulled automatically.

8.3.4 - TURBO function

• In TURBO mode, the fan motor functions at a very high speed in a way to reach the temperature set in
the least time possible.

8.3.5 - SELF CLEAN function

• In SELF CLEAN mode, the air conditioner automatically cleans and dries the evaporator and keeps it
fresh for successive use.
The function is used on switch off of cooling mode to clean the evaporator and keep it fresh for successive
use.
This function is easy to activate and accessible from the remote control.
• The air conditioner will operate as follows:
- Fan only mode with fan at low speed (13 minutes) -
- Heating with fan at low speed (1 minute)
- Fan only operation (2 minutes)
- Stop operation
- Unit switch-off.
This function is only available in COOL (AUTO COOL, FORCED COOL) and DRY modes.
Before selecting this function, it is recommended to start the air conditioner in cooling
mode for approx. 30 minutes.
Once the Auto Clean function is activated, all timer settings will be annulled.
If the AUTO CLEAN button is pressed again during operation in auto-clean mode, the
function stops and the appliance switches off.

8.3.6 - SILENCE function

• This function reduces noise.

8.3.7 - FP function

• The FROST PROTECTION function sets the temperature at 8°C.
The function is available in "HEAT" mode only.

8.3.8 - TIMER keys (7 and 8)

• These keys are used to set the switch-on "ON" and switch-off "OFF" time of the air conditioner.

8.3.9 - SILENCE/FP key (9)

• Press this key for less than 2 seconds to start the SILENCE function.
If the key is held down for more than 2 seconds, the FP (FROST PROTECTION). function is activated.
EN - 38