Installation Diagram - Olimpia splendid NEXYA S5 E DUAL Hinweise Für Die Verwendung Und Pflege

The relations between H, A and L are as follows.
as follows.
L
25 cm / 9.8" or more
L ≤ 1/2H
L ≤ H
1/2H < L ≤ H 30 cm / 11.8" or more
L > H
Can not be installed

2.5 - INSTALLATION DIAGRAM

4
• To prevent wall damage, use a stud
Safety Precautions
finder to locate studs.
• A minimum pipe run of 3 metres is
CAUTION
required to minimise vibration & ex-
To prevent wall damage, use a stud finder to
•
cessive noise.
• Two of the A, B, and C air circulation
locate studs.
• A minimum pipe run of 3 metres is required
pathways must be free from obstruc-
to minimise vibration & excessive noise.
tions at all times.
Two of the A, B, and C air circulation pathways
• This illustration is for demonstration
•
must be free from obstructions at all times.
purposes only.
• The actual shape of your air conditioner
This illustration is for demonstration
•
may be slightly different.
purposes only.
• Copper lines must be independently
The actual shape of your air condtioner may
•
insulated.
be slightly different.
Copper lines must be independently insulated.
•
The installation must be performed in ac-
cordance with the requirement of local and
NOTE: The installation must be performed in
national standards. The installation may be
accordance with the requirement of local and
slightly different in different areas.
national standards. The installation may be
slightly different in different areas.
EN - 16
A
3
Remote
controller
holder
5
Dual
Trial
Quadri
Penta
>
H
Mounting screw
2
ST3.9×25-C-H
Air-break
Installation plate
Switch

(1)
Mounting screw
ST3.9×25-C-H
Remote
controller
holder
L
1
Clip anchor
Air-break Switch
1
2
Drainage
Pipe
5 4 3

Outdoor Unit
Power Cable
The maximum
amount of the
connection cables is 5.
This section is for
reference only.
Installation
plate
Clip anchor
Refrigerant
pipe
(2)
 