Step 2: Install Drain Joint (Heat Pump Unit Only); Step 3: Anchor Outdoor Unit; Unit Mounting Dimensions - Olimpia splendid NEXYA S5 E DUAL Hinweise Für Die Verwendung Und Pflege

If the unit is frequently exposed to heavy rain or snow:
Build a shelter above the unit to protect it from the rain or snow. Be careful not to obstruct air flow around
the unit.
If the unit is frequently exposed to salty air (seaside):
Use outdoor unit that is specially designed to resist corrosion.

2.3.3 - Step 2: Install drain joint (Heat pump unit only)

Before bolting the outdoor unit in place, you must install the drain joint at the bottom of the unit. Note that
there are two different types of drain joints depending on the type of outdoor unit.
Fase 2: Installare il giunto di scarico (solo unità
If the drain joint comes with a rubber seal (see Fig. A), do
pompa di calore)
the following:
1. Position the seal on the drain joint.
2. Insert the joint on the hole located on the external base
of the unit.
3. Turn the joint 80° until you hear the click and place it
frontally.
seguenti operazioni:
4. Connect a drain tube to the joint (not supplied) and
direct it into a catch pit.
If the drain joint doesn't come with a rubber seal (see Fig.B),
do the following:
1. Insert the joint onto the hole located on the base of the
external unit.
2. Turn the joint 80° until you hear the click and position it frontally.
3. Connect a drain tube to the joint (not supplied) and direct it into a catch pit.
In cold climates, make sure the drain tube is as vertical as possible to ensure quick drainage
of water. If water drains too slowly, it may freeze in the tube and damage the unit.
seguenti operazioni:
arico (solo unità

2.3.4 - Step 3: Anchor outdoor unit

staffa montata a parete con bullone (M10). Preparare la
The outdoor unit can be anchored to the ground or to a wall-mounted bracket with bolt (M10). Prepare the
installation base of the unit according to the dimensions below.
DIMENSIONI DI MONTAGGIO UNITÀ

2.4 - UNIT MOUNTING DIMENSIONS

), effettuare le
The following is a list of different outdoor unit sizes and the distance between their mounting feet. Prepare
the installation base of the unit according to the dimensions below.
Tipi e specifiche delle unità esterne
90 gradi fino a quando
), effettuare le
u
Ruotare il giunto di scarico di 90 gradi fino a quando
su
Unità esterna tipologia split
Raccordo
W
W
Outdoor Unit Dimensions
W × H × D (mm)
946x810x410
805x554x330
890x673x342
staffa montata a parete con bullone (M10). Preparare la
DIMENSIONI DI MONTAGGIO UNITÀ
), effettuare le
Tipi e specifiche delle unità esterne
), effettuare le
H
TOGLIERE IMMAGINE IMMAGINE CON DOPPIA VENTOLA
Distance A
673
511
663
Base pan hole of
outdoor unit
Seal
Seal
Drain joint
(A)
 
A
D
Mounting Dimensions (mm)
Distance B
(B)
B
403
317
354
EN - 15
NEXYA S5 E