External Unit Wiring; Wiring Of The Internal Unit; Electric Connection Between Indoor And Outdoor Units - Olimpia splendid NEXYA S5 E DUAL Hinweise Für Die Verwendung Und Pflege

3.1 - EXTERNAL UNIT WIRING

1. Remove the junction box cover of the external
unit.
are le alette a U ai terminali. Abbinare i colori / etichette del filo con le etichette sulla morsettiera
3. Collegare le alette a U ai terminali. Abbinare i colori / etichette del filo con le etichette sulla mors
2. Connect the cables to the terminals. Pair the
colours / labels of the wire with the labels on the
are l'aletta a U di ciascun filo al terminale corrispondente.
e avvitare l'aletta a U di ciascun filo al terminale corrispondente.
terminal box.
3. Tighten the single terminals.
i fili inutilizzati con nastro elettrico. Tenerli lontani da eventuali parti elettriche o metalliche.
4. Insulate the unused wires with electric tape. Keep
5. Isolare i fili inutilizzati con nastro elettrico. Tenerli lontani da eventuali parti elettriche o metallich
them away from possible electric or metallic parts.
5. Reposition the cover of the junction box.
3.2 - WIRING OF THE INTERNAL UNIT (Figure 14a)
Prepare the cable for connection by stripping the insulating sheath at the ends of the conductors and crimp
the terminals of the "U" type at the ends of the conductors.
a. Open the front panel of the internal unit.
b. Use a screwdriver to open the lid (22) of the clamps compartment at the right side of the unit.
ALL THE CONNECTIONS MUST BE CARRIED OUT EXACTLY AS INDICATED IN THE
WIRING DIAGRAM.
c. Unscrew the cable tie (23) under the terminal box.
d. Make the signal cable pass through the opening on the left side, from the back of the unit towards the
front.
e. Correctly connect the cables to the terminal box (24).
f. Close the lid (22) and reassemble the plastic rear panel.

3.3 - ELECTRIC CONNECTION BETWEEN INDOOR AND OUTDOOR UNITS

The connection diagrams are shown inside the lid (22) and (26) of the clamps of the internal and external units.
page. The connection cable between the outdoor unit and the indoor units must be the "H07RN-F" type.
Connect the connective cables to the terminals, as identified, with their matching numbers on
the terminal block of the indoor and outdoor units. For example, Terminal L1(A) of the outdoor
unit must connect with terminal L1/1 on the indoor unit. The outdoor unit can match different
types of indoor unit, the numbers on the terminal block of the indoor unit may be slightly dif-
ferent. Please pay special attention while connecting the wire.
prestare particolare attenzione durante il collegamento del filo.
prega di prestare particolare attenzione durante il collegamento del filo.
EN - 24
TOGLIERE
TOGLIERE
VERIFICARE CON FORNITORE
VERIFICARE CON FORNITORE
Cover
Screw
or
or