Installation; Positioning The Unit; Installation Modes; Minimum Installation Distances - Olimpia splendid Bi2 SL SMART S1 Serie Installationsanweisung Und Wartung

2 - INSTALLATION

2.1 - POSITIONING THE UNIT

Avoid installing the unit in proximity to:
- positions subject to exposure to direct sunlight;
- in proximity to sources of heat;
- in damp areas or places with probable contact with water;
- in places with oil fumes
- places subject to high frequencies.
WARNING
A failure to apply the indicated standards, which may cause malfunctioning of
the equipment, relieves OLIMPIA SPLENDID from any form of warranty and from
possible damages caused to people, animals or property.
Make sure that:
a. the wall on which the unit is to be installed is strong enough to support the weight;
b. the part of the wall interested does not have pipes or electric wires passing through;
c. the interested wall is perfectly flat;
d. there is an area free of obstacles which could interfere with the inlet and outlet air flow;
e. the installation wall is preferably an outside perimeter wall to allow the discharge of the con-
densation outside;
f. in case of ceiling installation the airflow is not directed towards persons.

2.2 - INSTALLATION MODES

The following descriptions of the various mounting phase and the relative designs refer to a version of the
machine with fixtures on the left.
The operations for the mounting of machines with fixtures on the right are exactly the same.
Only the images are to be considered as a mirror image.
To ensure that the installation is performed correctly and that the appliance will perform perfectly carefully
follow the instructions indicated in this manual. Failure to respect the rules indicated not only can cause
malfunctions of the appliance but will also invalidate the warranty and hence OLIMPIA SPLENDID shall
not respond for any damage to persons, animals or property.
The appliance must be installed in a position that allows the routine maintenance (filter cleaning) and the
extraordinary interventions to be carried out easily, giving access to the air breather valves (battery and
plate), reachable from the upper grill on the fixtures side.

2.3 - MINIMUM INSTALLATION DISTANCES

Figure 5 indicates the minimum mounting distances between the wall-mounted cooler-convector and
furniture present in the room.

2.4 - SIDE OPENING

- Lift the cover (fig. 6 ref. H) that protects the screw (fig. 6 ref. L) and unscrew it.
- Move the side panel slightly to the right and lift it out (fig. 6 ref. P).
EN - 42