Side Broom Height Check And Adjustment; Side Broom Disassembly/Assembly - Nilfisk SW 750 Betriebsanleitung

SIDE BROOM HEIGHT CHECK AND
ADJUSTMENT
1. Check the side broom distance from the fl oor as shown
below:
• Drive the machine on a level ground and lower the side
broom.
• Keep the machine stationary and turn on the side
broom for a few seconds.
• Turn off the side broom by pressing the switch (1), then
lift it and move the machine.
• Check that the side broom print is as shown in the
fi gure (A, Fig. 1): the side broom must touch the ground
along a circle arc ranging from "10 o'clock" position to
"3 o'clock" position.
• If the print is not within specifi cations, adjust the broom
height as shown in step 2.
2. Turn the knob (13) clockwise and counter-clockwise to
adjust the broom height.
3. Perform step 1 again to check the proper adjustment of the
side broom height.
4. When the broom is too worn to be adjusted, replace it as
shown in the next paragraph.

SIDE BROOM DISASSEMBLY/ASSEMBLY

CAUTION!
It is advisable to wear protective gloves when
replacing the side broom because there can be
sharp debris between the bristles.
1. Drive the machine on a level fl oor.
2. Turn the main switch (1) to "0".
3. Lift the side broom.
4. Loosen the knob (A, Fig. 2) inside the side broom, then
remove the broom (B) by disengaging it from the pins (C).
5. Install the new broom by engaging it on the pins (C), then
tighten the knob (A).
6. Adjust the new broom height as shown in the previous
paragraph.
USER MANUAL
B
SW 750 146 3080 000(2)2008-08 A
ENGLISH
10
A
Figure 1
C
A
Figure 2
11
3
S311350
S311351