Skirt Height And Operation Check; Battery Charging - Nilfisk FLOORTEC 350 Bedienungshandbuch

ENGLISH

SKIRT HEIGHT AND OPERATION CHECK

1. Drive the machine on a level floor that is suitable for
checking the skirt height.
2. Turn the main switch (1) to "0".
3. Check that the distance from the ground of the side skirts
(A and B, Fig. 11) is 0 - 2 mm.
Check the skirts for integrity, cuts or tears, which can
reduce the machine vacuum capabilities. If necessary
replace the side skirts (see the procedure in the Service
Manual).
4. Check that the front and rear skirts (C and D, Fig. 11)
slightly rub on the ground. Check the skirts for integrity,
cuts or tears, which can reduce the machine vacuum
capabilities. Note that the front skirt has typical vertical
cuts (E). If necessary replace the front and rear skirts (see
the procedure in the Service Manual).

BATTERY CHARGING

1. Drive the machine to the appointed recharging area and
ensure that it cannot move independently.
2. Turn the main switch (A, Fig. 12) to "0".
3. Remove the battery charger cable (B) from the housing (C)
and connect it to the electrical mains.
CAUTION!
Before connecting the battery charger (B), ensure
that frequency and voltage values, shown on
the machine serial number plate (33), match the
electrical mains voltage.
In case of doubt, do not connect the plug to
the electrical mains, but contact the qualified
personnel.
4. While charging the batteries, the red warning light (D) and
the yellow warning light (E) turn on in sequence.
When the green warning light (F) turns on, the batteries
are charged.
5. Disconnect the battery charger cable (B) from the electrical
mains and place it in the housing (C).
NOTE
When the battery charger is connected to the
electrical mains, all machine functions are
automatically disabled.
16
USER MANUAL
FLOORTEC 350
D
A
A-B
0-2 mm
0-0.08 in
Figure 11
Figure 12
146 3083 000(2)2008-11 A
B
E
C
D
C
S311360
A
F
E
D
B
C
S311361