Inserting/Removing The Telescopic Tube; Mounting/Removing Suction Nozzles - Cleanmaxx HJX1406-D Gebrauchsanleitung

EN

Inserting/removing the telescopic tube

Adjusting the length of the telescopic tube

Mounting/removing suction nozzles

Mounting/removing the dust container
22
• Insert the open end of the handle into the corresponding
opening of the telescopic tube. At the same time twist the
handle gently backwards and forwards. Afterwards, check
the connection for secure seating.
• To remove the telescopic tube, pull it out of the handle.
• Push the slider on the telescopic tube and set the desired
length.
• Release the slider and move the tube forward until it locks
into place.
• Insert the free end of the telescopic tube as far as it will go
into one of the suction nozzles supplied. At the same time
twist the nozzle gently backwards and forwards.
• For greater fl exibility the suction nozzles can also be con-
nected directly to the suction hose without using the tele-
scopic tube.
• To remove a suction nozzle simply pull it out.
• Removing: Push the release button of the dust container
and take it out of the motor unit by the handle.
• Mounting: Take dust container by the handle and insert
it bottom fi rst into the motor unit. Then push the handle
towards the motor unit housing until the dust container
audibly clicks into place. Hold the device by the dust con-
tainer handle and lift it up to check that the dust container
is correctly locked into place.