Cleanmaxx 05767 Gebrauchsanleitung Seite 20

EN
4. Twist the metal fi lter anticlockwise and
pull it out of the fi lter holder (Picture
D1).
5. Tap out all parts and clean them with
a soft brush if necessary.
6. The fi lter holder and metal fi lter can
also be rinsed with clear water.
NOTICE: Do not wet-clean the H11
HEPA fi lter!
7. Wipe the dust container with a damp
cloth if necessary and then dry it or
allow it to dry in the air. Never as-
semble wet or damp components or
attach them to the motor unit!
Assembly
1. Insert the metal fi lter into the fi lter
holder and twist it clockwise until it
fi ts securely (Picture D2).
2. Insert the fi lter holder with metal fi lter
into the dust container so that the two
recesses fi t directly above one anoth-
er (Picture E). The fi lter holder must fi t
correctly in the dust container, it must
not stick out at the top.
3. Place the H11 HEPA fi lter on top of
the fi lter holder.
4. Insert the dust container back into the
motor unit. It must engage audibly.
Cleaning the Motor Unit, Extension
Tube and Nozzles
• Wipe down the motor unit (E), exten-
sion tube (F) and nozzles with a damp,
soft cloth if necessary. Then dry with a
soft cloth.
• Regularly remove hair and fl uff from
the nozzles and brushes.
Cleaning the Floor Nozzle
To make it easier to clean, the brush
can be removed from the electric fl oor
nozzle (I):
1. Slide the latch fastener on the bottom
of the electric fl oor nozzle towards
18
the small wheel on the electric fl oor
nozzle (Picture F1).
2. Open the latch and remove (Picture
F2).
3. Take out the brush and remove any
dirt and contamination.
4. Reinsert the brush. When you do this,
insert the end with the star-shaped
recess fi rst.
5. Insert the latch and slide the latch
fastener back in place.
Storage
• Store the device and accessories in
a cool, dry place which is protected
from direct sunlight and is out of the
reach of children and animals.
• For easy storage and to save space,
the brush nozzle (A) and crevice noz-
zle (G) can be secured to the holder
for brush and crevice nozzle (H) on the
extension tube (F) (Picture G).
• Hang the motor unit (E) with the suc-
tion opening (12) facing downwards
into the wall mounting bracket (B).
 
If the device is not going to be
used for a prolonged period, re-
move the battery (C) to be on the
safe side: Flip up the small clip
on the bottom of the battery and
pull out the battery downwards
(Picture H).
To prevent a deep discharge of
the battery, charge it up every
3 months if it is not used for a
prolonged period.