PeakTech 1195 Bedienungsanleitung Seite 108

Record menu list:
Menu Setting
Record
Playback
Mode
Storage
Off
End frame 1-3000
Play
Operate
Stop
Interval 1ms~1000s
On
Refreshed
Off
Increase
Direction
Decrease
Note:
Both the waveforms are recorded at record mode. If one channel is off when recording, the channel data is not
available at Playback mode.
Playback: Playback the recorded waveforms.
Playback menu list:
Menu Setting
Loop
Play mode
Single
Play
Operate
Stop
Interval 1ms-20s
Start frame 1-3000
Cur frame 1-3000
End frame 1-3000
Increase
Direction
Decrease
Note:
The Run/Stop button can also replay or continue the waveform display.
Storage: Store recorded waveforms in non-volatile memory according to the setup frames.
Instruction
Select record mode.
Select playback mode.
Select storage mode.
Turn off all recorder functions.
Set number of record frames.
Press to start recording.
Press to stop recording.
Set time interval between record frames.
To next menu
The waveforms are in the state of refreshing when recording.
The waveforms stop refreshing when recording.
The value increases from that of end frame to time interval.
The value decreases from that of end frame to time interval.
Back to previous menu.
Instruction
Set repeat play mode.
Set single time play mode.
Press to start playback.
Press to stop playing.
Set up interval value between frames.
To next menu
Set start frame.
Select current frame to be played.
Set End frame.
The value increases at the mode of setting start frame, cur frame
and end frame
The value decreases at the mode of setting start frame, cur frame
and end frame
Back to previous menu.
-107-