Operation - eQ-3 homematic IP HmIP-eTRV-2 Montage- Und Bedienungsanleitung

Operation

If the adapter run has been initiated prior to mount-
ing or if an error message (F1, F2, F3) is displayed,
press the control wheel/boost button (E) and the
motor reverses to the "
6 Operation
After pairing and mounting have been performed, simple
operations are available directly on the device.
If the radiator thermostat is in standby mode,
please press the control wheel (E) once before
operation to activate the device.
• Temperature: Turn the control wheel (E) to the right
or to the left to manually change the temperature
of the radiator. In automatic mode, the manually
set temperature will remain the same until the next
point at which the profile changes. Afterwards, the
defined heating profile will be activated again. Dur-
ing manual operation, the temperature remains ac-
tivated until the next manual change.
• Manual and automatic mode: Press and hold down
the control wheel (E) to switch between manual
and automatic mode. In automatic mode, the de-
fined heating profile of the Homematic IP app is
active. In manual operation, the temperature can
be set directly on the device or via the app and will
remain active until the next manual change.
50
" position.