eQ-3 homematic IP HmIP-eTRV-2 Montage- Und Bedienungsanleitung Seite 52

Replacing batteries
• Please pay attention to the flashing signals of the
device LED while inserting the batteries (see „8.4 Er-
ror codes and flashing sequences" on page 55).
Once the batteries have been inserted, the radiator ther-
mostat will perform a self-test (approx. 2 seconds). Af-
terwards, initialisation is carried out. The LED test display
will indicate that initialisation is complete by lighting up
orange and green.
Caution! There is a risk of explosion if the battery
is not replaced correctly. Replace only with the
same or equivalent type. Never recharge non-
rechargeable batteries. Do not throw the batter-
ies into a fire. Do not expose batteries to exces-
sive heat. Do not short-circuit batteries. Doing so
will present a risk of explosion.
Caution! Avoid skin and eye contact with leaking
batteries! Wear suitable protective gloves when
removing leaking batteries and residues from a
device! In case of skin contact flush with plenty of
water!
52