Maintenance And Cleaning - eQ-3 homematic IP HmIP-eTRV-2 Montage- Und Bedienungsanleitung

The factory settings of the device can be restored.
If you do this, you will lose all your settings.
To restore the factory settings of the radiator thermostat,
please proceed as follows:
Push the battery compartment cover (D) to the
•
back and downwards to remove it from the de-
vice (see figure 7).
• Remove the batteries.
• Insert the batteries ensuring that the polarity is
correct (see figure 8) while pressing and holding
down the system button (C) for 4s at the same
time, until the LED will quickly start flashing or-
ange (see figure 3).
• Release the system button again.
• Press and hold down the system button again for
4s, until the status LED lights up green.
• Release the system button to finish the procedure.
The device will perform a restart.
10

Maintenance and cleaning

The device does not require you to carry out any
maintenance other than replacing the battery
when necessary. Enlist the help of an expert to
carry out any maintenance or repairs.
Maintenance and cleaning
57