Operating modes and configuration
All manuals and user guides at all-guides.com
6.1
Automatic mode
In automatic mode, the temperature is controlled in ac-
cordance with the set heating profile (see „6.5.3 Heating
profile" on page 70). Manual changes that are set via
the control wheel (E) are activated until the next point at
which the profile changes. Afterwards, the defined heat-
ing profile will be activated again. To activate the auto-
matic mode, please proceed as follows:
•
Select the
wheel and confirm by pressing the control wheel
briefly.
6.2
Manual operation
In manual mode, the temperature is controlled in ac-
cordance with the current temperature set via the con-
trol wheel (E). The temperature remains activated until
the next manual change. To activate the manual mode,
please proceed as follows:
•
Select the
wheel and confirm by pressing the control wheel
briefly.
•
Turn the control wheel to set the desired tem-
perature.
You can fully close or open the vale of the floor
heating actuator by turning the control wheel (E)
as far as it will go in an anti-clockwise or clock-
wise direction. "OFF" or "On" is displayed.
64
symbol by turning the control
symbol by turning the control