Start-Up; Pairing - eQ-3 homematic IP HmIP-eTRV-2 Montage- Und Bedienungsanleitung

5

Start-up

5.1

Pairing

Please read this entire section before starting
the pairing procedure.
First set up your Homematic IP Access Point via
the Homematic IP app to enable operation of
other Homematic IP devices within your system.
For further information, please refer to the oper-
ating manual of the Access Point.
To integrate the radiator thermostat into your system
and enable it to communicate with other Homematic IP
devices, you must add the device to your Homematic IP
Access Point first.
To add the radiator thermostat, please proceed as fol-
lows:
• Open the Homematic IP app on your smartphone.
Select the menu item "Add device".
•
• Remove the insulation strip from the battery
compartment (D) of the radiator thermostat. pair-
ing mode remains activated for 3 minutes.
You can manually start the pairing mode for an-
other 3 minutes by pressing the system button (C)
shortly (see figure 3).
Start-up
41