Emissions - Optimum OPTidrill DP 26 Betriebsanleitung

Spindle seat
Drill table T-slot thread size
T-slot size
Table size
Spindle stroke
Throat depth
Column diameter
Distance spindle - drill table
Distance spindle - base
Drilling table swivelling / rotating
Dimensions
Weight of the machine
Spindle speeds
Speed steps
Ambient conditions Temperature
Relative humidity
2.1

Emissions

CAUTION!
The operator should wear noise and hearing protection.
The A-weighted sound pressure level L
The A-weighted sound power level L
INFORMATION
This numerical value was measured on a new machine under the operating conditions specified
by the manufacturer. The noise behaviour of the machine might change depending on the age
and wear of the machine.
Furthermore, the noise emission also depends on production engineering factors, e.g. speed,
material and clamping conditions.
INFORMATION
The specified numerical value represents the emission level and does not necessarily a safe
working level. Though there is a dependency between the degree of the noise emission and the
degree of the noise disturbance it is not possible to use it reliably to determine if further precau-
tion measures are required or not. The following factors influence the actual degree of the noise
exposure of the operator:
Characteristics of the working area, e.g. size or damping behaviour,

other noise sources, e.g. the number of machines,

other processes taking place in proximity and the period of time, during which the operator

is exposed to the noise.
Technical specification
Version 1.0.2 - 2022-04-06
max. 400 mm
max. 592 mm

"DP26 bench drill
dimension" on page 48
96 kg

is 70 to 73 dB.
pA
is 80 to 85 dB.
WA
Translation of original instructions
MT 3
M12
12mm diagonally running
309 x 309 mm
95 mm
209 mm
Ø 80 mm
max. 770 mm
max. 1300 mm
± 45° / 360°

"DP26 column drill
dimension" on page 49
105 kg
"Speed table" on page 59
12
5 ~ 35 °C
25 - 80 %
DP26 EN
47