Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Interval
Where?
in case of need
Every 6
months
Maintenance
Version 1.0.2 - 2022-04-06
What?
How?
Any
unusual
regreasing. The sleeve (1) moves downwards or upwards
with the toothed spindle (2) in the fixed driven sleeve (3)
during drill feed. The noises are caused by the necessary
clearance between the two toothings of the sleeve and
spindle. The grease in the delivery condition may have been
used up.
2
1
Img.5-1:
Regreasing is carried out from above via the spindle drive.
Apply grease at the visible toothed area of the spindle. It is
recommended
permanently inside the toothing. The grease "Staburag NBU
30 PTM" from Klüber is recommended and has proved to be
a successful assembly grease for clearance fits.
Check the electrical equipment / parts of the drilling machine.
"Qualification" on page 42
Testing
Translation of original instructions
rattling
noises
can
be
3
2
3
to
use
a
grease
which
eliminated
by
can
remain
DP26
EN
63
Werbung
Inhaltsverzeichnis
