Before Commissioning; Assembly - Scheppach HS110 Serie Original Bedienungsanleitung

Noise level
The noise values have been determined in accordance
with EN 62841.
Sound pressure level L
pA
Uncertainty K
pA
Sound power level L
WA
Uncertainty K
WA
Wear hearing protection.
Excessive noise can result in a loss of hearing. Total
vibration values (vector sum of three directions) deter-
mined according to EN 62841.
NOTE: The specified device emissions values have
been measured in accordance with a standardised test
procedure and can be used for comparison of one elec-
tric tool with another.
The specified noise emission values can also be used
for an initial estimation of the exposure.
m WARNING: The noise emission values can vary
from the specified values during the actual use of the
electric tool, depending on the type and the manner in
which the electric tool is used, and in particular the type
of workpiece being processed. Implement measures to
protect against noise nuisance. In doing so, take into
account the complete working process, including the
times when the power tool is working without load or
switched off. Suitable measures include regular main-
tenance and care of the power tool and the insertion
tools, regular breaks as well as proper planning of the
working process.

8. Before commissioning

• Open the packaging and carefully remove the de-
vice.
• Remove the packaging material, as well as the
packaging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the device and accessory parts for trans-
port damage.
• If possible, keep the packaging until the expiry of
the warranty period.
m DANGER
The device and the packaging are not children's
toys! Do not let children play with plastic bags,
films or small parts! There is a danger of choking
or suffocating!
97 dB(A)
3 dB
• The machine must be securely installed. To do so,
bolt it to a workbench, machine stand or similar. Use
110 dB(A)
the holes on the inner side of the frame legs for this.
3 dB
• Prior to commissioning, all covers and safety devic-
es must be mounted correctly.
• It must be possible for the saw blade to run freely.
• In case of previously machined wood, be aware of
any foreign objects, such as nails or screws, etc.
• Before pressing the on/off switch, make sure that the
saw blade is correctly fitted, and that moving parts
run smoothly.
• Before connecting the machine, make certain that
the data on the type plate matches with the mains
power data.
• Only connect the machine to a correctly installed
protective contact socket, with fuse protection of at
least 16 A.
9.

Assembly

m WARNING: Danger of injury!
Improper installation of the circular table saw may re-
sult in serious injury.
Before commissioning, properly and completely install
the circular table saw, including all covers and safety
devices.
Never plug the mains plug into the power socket before
completing the installation.
If connections are secured with a hexagonal bolt, nut,
spring washer and washer, the washer and spring
washer must be fitted under the hexagonal bolt. The
spring washer always lies directly on the (inner) hex-
agonal bolt or nut.
Hexagon screws must each be inserted from outside
inwards, and the connections must be secured from
the inside with nuts. During assembly nuts and screws
must only be tightened until hand-tight, so that they
cannot fall out.
If you tighten the nuts and screws fully before final as-
sembly, the circular table saw cannot be erected in a
correct and stable manner.
www.scheppach.com GB | 37