Before Starting The Equipment; Assembling The Equipment - Scheppach HS80 Original Bedienungsanleitung

*S1: Continuous operation at constant load
**S6 25% operating mode:
Continuous duty with intermittent loading (operating
time 10 min.)
In order avoid impermissible overheating of the motor,
the motor should be driven for only 25% of the operat-
ing time with the stipulated nominal power and must
then continue to run with no load for the remaining 75%
of the operating time.
Noise
The total noise values were determined in accordance
with EN 62841.
Sound pressure level L
pA
Uncertainty K ..................................................... 3 dB
pA
Sound power level L ..............................100.5 dB(A)
WA
Uncertainty K ..................................................... 3 dB
WA
Wear hearing protection.
The effects of noise can cause a loss of hearing. Total
vibration values (vector sum - three directions) deter-
mined in accordance with EN 62841.
NOTE: The specified device emissions values have
been measured in accordance with a standardised test
procedure and can be used for comparison of one elec-
tric tool with another.
The specified device emissions values can also be
used for an initial estimation of the load.
WARNING: The noise emission values can vary from
the specified values during the actual use of the elec-
tric tool, depending on the type and the manner in
which the electric tool is used, and in particular the type
of workpiece being processed.
Implement measures to protect against noise nui-
sance. In doing so, take into account the complete
working process, including the times when the electric
tool is working without load or switched off.
Suitable measures include regular maintenance and
care of the electric tool and the insertion tools, regu-
lar breaks as well as proper planning of the working
process.
............................ 87.5 dB(A)
www.scheppach.com
7.

Before starting the equipment

• Open the packaging and remove the device care-
fully.
• Remove the packaging material as well as the pack-
aging and transport bracing (if available).
• Check that the delivery is complete.
• Check the device and accessory parts for trans-
port damage.
• If possible, store the packaging until the warranty
period has expired.
m WARNING
The device and packaging materials are not toys!
Children must not be allowed to play with plastic
bags, film and small parts! There is a risk of swal-
lowing and suffocation!
• The equipment must be securely installed, i.e. bolt-
ed down on a workbench, base frame or similar. Use
the holes on the inner side of the frame legs for this.
• All covers and safety devices have to be properly
fitted before the equipment is switched on.
• It must be possible for the blade to run freely.
• When working with wood that has been processed
before, watch out for foreign bodies such as nails
or screws, etc.
• Before you press the On/Off switch check that the
saw blade is fitted correctly. Moving parts must run
smoothly.
• Before you connect the equipment to the power sup-
ply make sure the data on the rating plate are identi-
cal to the mains data.
• Connect the equipment to a properly installed pro-
tective contact socket, with at least 16 A circuit
breaker.

8. Assembling the equipment

m WARNING: Disconnect the mains power plug be-
fore maintaining, resetting or assembling the table
saw.
8.1 Before assembling the equipment
• Place all parts supplied on a flat surface.
• Group equal parts.
NOTE:
• If compounds with a bolt (round head / or hexagon),
hex nuts and washers are backed up, the washer
must be fitted under the nut.
GB | 35