Drill Depth Stop; Table Inclination; Drilling Table Rotate - Optimum OPTidrill DQ 20V Betriebsanleitung

4.7

Drill depth stop


Loosen the clamping screw and turn
the scale ring to the desired drilling
depth.

Tighten the clamping screw again.
The spindle can only be lowered to the set
value.
4.8

Table Inclination

CAUTION!
The further the drilling table is tilted to the left or right, the lower the carrying capacity
and the clamping action of the inclined drilling table.
The drilling table can be inclined to the right or to the left.

Loosen fixing screw (1).

Set the desired angle using the scale.

Tighten the fixing screw again.
4.8.1

Drilling table rotate


Release the clamping lever (2) and turn the table to the desired position.
1
When the angle scale with zero degree marking on the drill-
ing table is not sufficient for the desired accuracy. If neces-
sary, use an angular stop or dial gauge to set the table in a
desired position.
EN DQ20V
58
Scale
Clamping screw
2
Translation of original instruction
Img. 4-2: Scale of drill depth stop
Version 1.0.1 - 2021-05-11
Operation