Emergency Stop Switch; Drilling Table; Drill Chuck Guard; Prohibition, Warning And Mandatory Signs - Optimum OPTidrill DQ 20V Betriebsanleitung


are complete (replace if necessary).
INFORMATION
Organise the checks according to the following table;
General check
Equipment
Guards
Signs,
Markers
Date:
Functional check
Equipment

Drill chuck guard

Emergency stop button
Position switch of protective cover 
V-belt
Date:
1.11

Emergency stop switch

CAUTION!
The drilling spindle keeps turning for a short time even after actuating the emergency
stop switch depending on the preset speed.
1.12

Drilling table

Seats for T-slots are attached to the clamping table.
WARNING!
Risk of injury due to workpieces flying off at high speed. Securely fix the workpiece on
the drilling table.
1.13 Drill chuck guard
Adjust the guard to the correct height before you start working. To do this, loosen the clamping
screw, set the required height and tighten the clamping screws again.
1.14

Prohibition, warning and mandatory signs

INFORMATION
All warning signs must be legible. They must be checked regularly.
1.15

Personal protective equipment

For some works you need personnel protective equipment as protective equipment. These are

safety helmet,
Safety
Version 1.0.1 - 2021-05-11
check
Mounted, firmly bolted and not damaged
Installed and legible
Checked by (signature):
check
After opening the drill chuck guard, the drill must
switch off. The drill must not start when the chuck
guard is open.
After actuating the emergency stop switch, the bench
drill must switch off.
The bench drill must not be switched on, if the
protective cover of the V-belts is opened.
Checked by (signature):
Translation of original instruction
OK
OK
DQ20V EN
47