Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Interval
Where?
in case of need
EN
DQ20V
66
What?
How?
Any unusual rattling noises can be eliminated by regreasing.
The sleeve (1) moves downwards or upwards with the toothed
spindle (2) in the fixed driven sleeve (3) during drill feed. The
noises are caused by the necessary clearance between the two
toothings of the sleeve and spindle. The grease in the delivery
condition may have been used up.
2
1
Img. 6-3:
Regreasing is carried out from above via the spindle drive. Apply
grease at the visible toothed area of the spindle. It is recom-
mended to use a grease which can remain permanently inside
the toothing. The grease "Staburag NBU 30 PTM" from Klüber is
recommended and has proved to be a successful assembly
grease for clearance fits.
Translation of original instruction
3
2
3
Version 1.0.1 - 2021-05-11
Maintenance
Werbung
Inhaltsverzeichnis
