Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
CAUTION!
The grinding machine must be firmly connected to the substructure. For this purpose
there are holes in the base to screw the grinding machine to your worktable.
INFORMATION
In order to achieve high levels of functionality and machining accuracy, as well as a long ser-
vice life of the machine, the set-up location should meet certain criteria.
The following points should be noted:
The device must only be installed and operated in a dry and well-ventilated place.
The work table must be suitable for the belt grinder. If necessary, this table must also be
firmly connected to the subfloor.
Provide enough space for set-up and operating personnel and material transport.
Ensure adequate lighting is available (minimum value: 500 Lux, measured at support sur-
face for workpiece). In the event of a lower level of lighting, additional illumination must be
provided, e.g. by means of a separate workplace light.
The power plug of the grinding machine must be readily accessible.
CAUTION!
Arrange the machine's connection cable in such a way that it will not cause a tripping
hazard.
3.5.2
Extraction socket
For certain operations, it may be appropriate to connect the grinding machine to an extraction
system or to an industrial vacuum cleaner. The suction connection on the belt sander is Ø 30
mm. The suction connection on the grinding wheel Ø 35 and Ø 50 mm.
Use both extraction ports simultaneously or only one of the two extraction ports that best suits
the purpose of extraction using the material.
3.6
First commissioning
For first commissioning, the grinding wheel must be trued with a dressing stone to ensure the
true running of the grinding wheel.
Grinding wheels made of bonded abrasive (usually aluminium oxide Al
corundum) have a natural delivery imbalance due to the press curtain in the manufacturing pro-
cess. Compound grinding wheels have a higher or lower density in some areas. This natural
imbalance cannot be removed with a dressing stone. However, the imbalance of the machine
can be reduced by turning the grinding wheel, e.g. by 180° on the grinding wheel shaft.
Delivery, interdepartmental transport and unpacking
Version 1.0.2 - 2021-03-10
Translation of original instruction
O
or also referred to as
2
3
GU30S
EN
33
Werbung
Inhaltsverzeichnis
