Timer Function; Use As A Timer; Use As A Cooking Time Limit - hanseatic MC-IF7242H1B3C Gebrauchsanleitung

Timer function

You can use the timer function as a timer or a
cooking time limiter for one or more cooking
zones.
The maximum timer setting is 1 to 99 min-
utes.

Use as a timer

Requirement: The hob is switched on.
Setting the alarm time
8 10
8
(8)
1. Touch the timer sensor '+' (8).
10
' ' will appear on the display with the nu-
meral '0' flashing.
2. Touch the '+' or '-' sensor to increase or
decrease the alarm time by one minute (1
to 99 min.).
If you touch the '+' or '–' sensor and then
press and hold it, the alarm time will change
in increments of 10 minutes.
The countdown automatically begins after
setting the alarm time.
The time display will stop flashing after ap-
prox. 5 seconds.
After the time which you have set has
elapsed, an acoustic signal will sound and
the hob will switch off.
Changing the alarm time
• Touch the timer sensor (8).
The minutes remaining flash on the display
for a few seconds.
While the display is flashing, the setting
can be changed (see „Setting the alarm
time" on page EN-17).
Timer function
Countdown stop
8
8
• Touch the '+' and '–' sensors simultane-
ously in order to cancel the countdown.
'00' will appear on the display. The count-
down is interrupted.

Use as a cooking time limit

8
Requirement: The cooking zone(s) to be se-
8
lected is/are in operation.
Notes on cooking time limit
– You can set cooking time limits for all cook-
ing zones.
– If you have activated a cooking time limit
for several cooking zones, the red dot on
the heat setting display of the cooking zone
flashes with the shortest cooking time limit
setting.
– Once the cooking time limit for a cooking
zone is reached, this cooking zone auto-
matically switches off.
– If all cooking zones are switched off, the
hob will also switch off automatically after
a few seconds.
Page EN-17
00 8
8