Yamaha WaveRunner GP1300R Ergänzendes Wartungshandbuch Seite 94

JET
PUMP
IMPELLER DUCT AND DRIVE SHAFT
5. Install:
• Rear bearing
Drive shaft needle bearing depth
stop:
YB-34474
NOTE:
• Press the bearing inner/outer race at the
same time holding the drive shaft and impel-
ler duct.
• If a bearing inner/outer race attachment is
not available, use a washer or pipe with an
outer diameter of 46 mm (1.81 in) and an
inner diameter of 20 mm (0.79 in).
6. Add:
• EPNOC grease AP #0 (into the cap)
Quantity:
20 g (0.7 oz)
7. Install:
• Nut
• Impeller
Drive shaft nut:
74 N • m (7.4 kgf • m, 53 ft • lb)
Impeller:
75 N • m (7.5 kgf • m, 54 ft • lb)
LOCTITE 572
Drive shaft holder:
YB-06151
Drive shaft holder 5:
90890-06519
35
E