Saving, Retrieving And Deleting Results; Cleaning And Storing The Instrument; Rectifying Faults; Specifications - Beurer BM 16 Gebrauchsanleitung

The WHO classification in the display shows the range of the
measured blood pressure.
If the values for systolic and diastolic pressure are in two
different WHO ranges (e.g. systolic in the grade hypertension
range and diastolic pressure in the normal range), the WHO
classification on the unit always indicates the higher range
(grade hypertension in the example described).

6. saving, retrieving and deleting results

The computer automatically saves the blood pressure
readings of the last 50 measurements. When the 50
memory locations are exceeded, the current oldest value
is deleted.
You can display the memory as follows:
• Press the "User-Switching key"
zone, and press the "M" key to switch from memory to
memory with sequence numbers.
• The saved measured values are continuously stored.
• Press the On/Off switch
• If you forget to switch off the computer, it will switch off
automatically after 1 minute.
Press the "User-Switching key"
zone, then press and hold the "M" key for approximately
5-seconds to clear the data in the pre-designated memory
zone. The data in both memory zones – zone 1 and zone 2 may
be erased if any of the batteries is removed.

7. Cleaning and storing the instrument

• Clean your blood pressure computer carefully only with a
slightly moistened cloth.
• Do not use detergents or solvents.
to select a memory
to turn the unit off.
to select a memory
• On no account must you immerse the computer in water,
otherwise liquid can enter it and cause demage.
• When storing the device, make sure that no heavy objects
are placed on top of it. Remove the batteries. The cuff tube
should not have any sharp kinks.

8. Rectifying faults

Error messages can occur when
• the blood-pressure value is unusually high or low („EE" ap-
pears in the display),
• you move or talk during the measurement („EE" appears in
the display),
• the cuff tube is not properly inserted („E1" appears in the
display),
• inflation takes longer than 20 seconds („E1" appears in the
display),
• the inflation pressure is higher than 300 mmHg („E2" appears
in the display),
• an error occurs when storing the measured values („E3" ap-
pears in the display).
• Exceeding measurement range („Er"appears in the display).
In the about cases, you must repeat the measurement. Make
sure that the cuff tube is properly inserted and that you do not
move or talk. Put the batteries back in if necessary, or else
replace them.

9. specifications

Model No.
Method of Measurement Oscillometric, non-invasive blood
16
BM 16
pressure measurement on the upper
arm